Specialized insulation contractor

Serving the commercial and industrial market
Polyurethane foam
comfort foam
Sona Spray FC
Ure-K Spray
Contact Us
K-13 Spray-On Systems®
Approvals and Ratings

These fire ratings are derived from product tests per ASTM standards and are used solely to measure and describe properties of materials and products in response to heat and flame under controlled laboratory conditions.  They are not intended to reflect hazards presented by these or any other materials under actual fire conditions.
Fire Performance Ratings
K-13 has been rated and approved by Factory Mutual Research Corporation for use in the following categories:
  • Category I: As an interior finish materail of low fire hazard (Class I Building Material) over noncombustible surfaces not requiring automatic sprinkler protection in and of itself.
  • Category II: As a protective coating to delay the ignition and reduce the surface burning rate of combustible wood and cellulosic fiber building materials.
  • Category III: As a protective coating to delay the ignition and reduce the surface burning rate of low melting, combustible cellular plastic building materials and to protect their dimensional stability for a brief period.
  • Category IV: As a protective coating for building structural steel to supplement automatic sprinkler protection in preventing structural failure temperatures of the steel in high fire hazard occupancies.
  • Category V: As a protective coating to the underside of Class II insulated steel roof deck construction to sufficiently lower the rate of fuel comtribution from the Class II deck components to qualify the construction as Class I allowing automatic sprinkler protection to be omitted where permissible under Factory Mutual Standards.
    Surface Burning Characteristics
    K-13 has a Class 1, Class A flame spread rating per ASTM E-84, UL-723, NFPA-255 and UBC-42.

    Flame spread - 5
    Smoke developed - 5
    Underwriter's Laboratories - Ref #R5499

    One-Hour Fire Wall
    Fire Endurance Tests

    Wall assemblies tested in accordance with full scale ASTME-119 including hose stream test.
    ASTM Standards Compliance
    ASTM-C-177   Thermal conductivity
    ASTM E-119   Full Scale Fire Wall Test, including Host Stream Test
    ASTM E-84   Surface Burning Characteristics
    ASTM C-423   Noise Reduction Coefficients
    ASTM C-523  Light Reflectance
    ASTM E-736   Bond Strength
    ASTM E-859   Air Erosion
    ASTM C-739   Moisture Absorption
    ASTM E-90   Sound Transmission Loss
    ASTM E-413   Sound Transmission Loss
    ASTM E-1042   Acoustical Absorption
    ASTM C-1149   Spray-applied Cellulose Insulation
    Test reports available upon request
    Miscellaneous Approvals and Specifications
    ICBO - No. 2262
    SBCCI - No. 9566
    Underwriter's Laboratories - Ref No R5499
    Los Angeles - RR-24311
    New York - 79-73-SM
    Dade County - 92-0107.8
    Federal Defense Logistics Agency Cage Code - ONJU2
    Department of the Navy Guide Specifications - 07218
    Corps of Engineers Guide Specifications - CE-201.01
    Federal Specification - SS-S-111C
    Factory Mutual Research - Report Nos 19678, 20399 and 24703
    Meets California Bureau of Home Furnishings Standards
    Resource Conservation and Recovery Act - EPA 40 CFR Part 248

    Industrial Coatings Co., Inc is a second generation, 50-year company employing only union labor.

    For more information, contact:
    Industrial Coatings Co., Inc

    send us an email

    © 2001 Industrial Coatings Co., Inc. All rights reserved.
    Design by Midwest Web Design